<< Click to Display Table of Contents >> Navigation: Sensor Settings > Capture Results Delivery > Setting up the Configurator > INFOWATCH Profiles |
Setting up INFOWATCH Profiles
Fig. 30. INFOWATCH profile settings.
1. Name and status
Profile name:
Administrators can select any profile name that is helpful, meaningful and easy to remember.
Profile is used by default:
Yes means that this profile is used by default.
2. INFOWATCH Settings
Server address:
The IP address or domain name of the InfoWatch Traffic Monitor server.
Port:
InfoWatch Traffic Monitor server port (default value is 9101).
Keep connection:
Send messages using the same connection to the server that is receiving messages. If this option is disabled, then each message will be sent via a separate TCP connection.
3. Identification
Token name:
The token name specified in the InfoWatch Traffic Monitor settings (default value is "microolap").
Token content:
The token contents specified in the InfoWatch Traffic Monitor settings.
EtherSensor server IP address:
The IP address of the EtherSensor server. It allows the InfoWatch Traffic Monitor server to distinguish different instances of the same data source.
The DNS name of the EtherSensor server:
The DNS name of the EtherSensor server. It allows the InfoWatch Traffic Monitor server to distinguish different data sources.
4. Message format
Message format:
Stored message format (EML, XML, JSON...)
5. Error handling
Timeout after failure:
Timeout for message delivery in the event of receiver rejection. Provide a value in seconds.
6. For GROUP profiles
Weight:
Determines a ratio for distribution of messages among receivers. Possible values are from 1 to 10 and the setting is valid only when used in a group profile.
Reserve profile:
Enable/disable the use of the reserve profile. If this setting is enabled and the main (non-reserve) delivery profiles fail, this profile will be used for message delivery. The setting is valid only when used in a group profile.